How To Assemble a Skateboard
by Fred Riehl at www.BraveSurf.com
Things
you will need:
1 Skate board deck
 1
sheet skate board deck griptape
2 skateboard trucks
4 skateboard wheels
8 skateboard wheel bearings
2 risers
1 set of mounting hardware
1 philips head screwdriver
1 skate tool
1 metal file
1 sharp razorblade
1. First apply the skate board deck grip tape. By unpeeling the backing
and then carefully stick the tape evenly on the top surface of the
skate deck. File down the grip tape around the edges of the skateboard,
and then carefully use the razorblade to slice off the excess grip
tape that hangs over the edges on the skatedeck.
2. Next, attach your skate trucks to your skateboard deck. Use one of the screws
from the mounting hardware to poke a hole in the griptape. Then push the mounting
hardware from the top of the skatedeck to the bottom.
3. Now slide the risers over the hardware. Next slide your skate trucks on.
Make sure that the bushings from the trucks point toward each other or face
the center of the board. Tighten the nut with the skate tool until it's flush
with the trucks. Warning: Do not over tighten; you can cause the wood to split.
4. Now press the bearings into your wheels using the skate tool. Repeat this
for all four wheels. If you do not have a skate tool. You can use your axe
on the trucks by placing the bearing on the axel and then pressing the wheel
into the bearing, causing the bearing to slip into the wheel. Warning: Be very
carefull not to dent or pinch the metal seal around the sides of the bearing.
This will ruin the bearings and cause them not to spin!
5. Once the bearings are in place, you can put the on the trucks. Do not over
tighten this will crush the bearing causing it not to role.
6. Now the board is ready to skate. You may need to fine tune the trucks to
your liking by loosening them or tighten them. The looser the trucks the easier
to carve.
7. Once you are done you can always customize your board with some stickers
Remember to skate safe and wear your pads when needed.
About the Author
Fred Riehl has been surfing and working with Brave New World surf shops
for 18 years!
The Tube Quest Continues at ... www.bravesurf.com
return to top |
|
